ArizonaShooting.com

I have an older Interarms (CZ action) mauser bolt gun, that has a thumb safety on the side, connected to the trigger asembly.

I have never broke this bolt down, but, I had a lite strike yesterday, and thought it was about time to see what condition the pin and spring are in.

I thought I could just break it down like a mauser bolt with safey on he bolt,... big mistake.

I pushed the plunger in, to twist off the shroud, and it felt like I released tension on something, but, the shroud won't twist off.

I now can not put the bolt back in the gun, either.

I have searched, and searched, but, the only disassembly instructions I have found, is for the mauser action with the safety on the bolt.

Any help, would be greatly appreciated.


leverman

Leverman, its probably one of the Mark Xs. Here is a link to the original guide. Wish I could offer more but I have only done military models.

http://stevespages.com/pdf/interarms_mkx.pdf

Hope it helps!


Jay

Thank you sir,... got'er done,... only takes a few seconds, when ya have the right info !!!



again, thanx Jay,
leverman

Not a problem, Sir. Glad you got it all worked out.

Jay